Filter
Top Products
29
EN
a. Pull the emergency draining hose out
from its seat
b. Place a large container at the end
of the hose. Drain the water into the
container by pulling out the plug at the
end of the hose. When the container
is full, block the inlet of the hose by
replacing the plug. After the container
is emptied, repeat the above procedure
to drain the water in the machine
completely.
c. When draining of water is finished,
close the end by the plug again and fix
the hose in its place.
d. Turn the pump filter to take it out.
Discharging the water when the product
does not have an emergency draining
hose:
a. Place a large container in front of the
filter to catch water from the filter.
b. Loosen pump filter (anticlockwise) until
water starts to flow. Fill the flowing
water into the container you have
placed in front of the filter. Always keep
a piece of cloth handy to absorb any
spilled water.
c. When the water inside the machine is
finished, take out the filter completely
by turning it.
4. Clean any residues inside the filter as
well as fibers, if any, around the pump
impeller region.
5. Install the filter.
A
If your product has a water jet feature,
be sure to fit the filter into its housing
in the pump. Never force the filter
while installing it into its housing. Seat
the filter into its place completely.
Otherwise, water may leak from the
filter cap.
6. If the filter cap is composed of two
pieces, close the filter cap by pressing
on the tab. If it is one piece, seat the
tabs in the lower part into their places
first, and then press the upper part to
close.