Filter
Top Products
27
EN
6 Maintenance and cleaning
Service life of the product extends and
frequently faced problems decrease if
cleaned at regular intervals.
Cleaning the detergent drawer
Clean the detergent drawer at regular
intervals (every 4-5 washing cycles)
as shown below in order to prevent
accumulation of powder detergent in time.
1. Press the dotted point on the siphon
in the softener compartment and pull
towards you until the compartment is
removed from the machine.
C
If more than normal amount of water
and softener mixture starts to gather in
the softener compartment, the siphon
must be cleaned.
2. Wash the detergent drawer and the
siphon with plenty of lukewarm water
in a washbasin. Wear protective gloves
or use an appropriate brush to avoid
touching of the residues in the drawer
with your skin when cleaning.
3. Insert the drawer back into its place
after cleaning and make sure that it is
seated well.
If your detergent drawer is the one
indicated in the following figure:
C
Lift the rear part of the siphon
to remove it as illustrated. After
performing the above mentioned
cleaning procedures, replace the
siphon back to its seating
and push
its front section downwards to make
sure that the locking tab engages.
Cleaning the loading
door and the drum
Residues of softener, detergent and dirt
may accumulate in your machine in time
and may cause unpleasant odours and
washing complaints. To avoid this, use
the Drum Cleaning programme. If your
machine is not featured with Drum Cleaning
programme, use Cottons-90 programme
and select Additional Water or Extra Rinse
auxiliary functions as well. Before starting
the programme, put max. 100 g of powder
anti-limescale into the main wash detergent
compartment (compartment nr. II). If the
anti-limescale is in tablet form, put only
one tablet into compartment nr. II. Dry the
inside of the bellow with a clean piece of
cloth after the programme has come to an
end.
C
Repeat Drum Cleaning process in every
2 months.
C
Use an anti-limescale suitable for the
washing machines.
After every washing make sure that no
foreign substance is left in the drum.
If the holes on the bellow shown in the
figure is blocked, open the holes using a
toothpick.
C
Foreign metal substances in your
machine will cause rust stains. Clean
the stains on the drum surface by using
cleaning agents for stainless steel.
Never use steel wool or wire wool.
Cleaning the body and
control panel
Wipe the body of the machine with soapy
water or non-corrosive mild gel detergents
as necessary, and dry with a soft cloth.