Filter
Top Products
22 - EN
BThe ventilation hose should not be connected
to the chimney of a stove or a fireplace.
BDo not operate your product at the same
time with heaters such as a coal or gas stove.
Airflow may cause the chimney to flare up.
Connection to water drain (Products
with a condenser);
In products equipped with condenser unit,
water accumulated during the drying cycle
accumulates in the water tank. You should drain
accumulated water after each drying cycle.
You can directly drain accumulated water
through the water drain hose supplied with the
product instead of periodically draining the water
collected in the water tank.
Connecting the water drain hose:
1. Pull the hose out by its end to remove it from
the product. Do not use any tools to remove
the hose. Attach the drain hose adaptor to
the end of this hose.
2. Connect the special drain hose supplied with
the product to the hose adaptor fitting.
3. Connect the other end of the drain hose
directly to the wastewater drain or to the
washbasin. The fitting must always be
secured in every type of connection. Your
house may flood if the hose comes out of its
housing during water discharge.
CWhen you direct the water drain to outside,
“Water Tank” warning light will turn on at the
end of each programme.
Important:
• The hose should be attached to a height of
maximum 80 cm.
• Make sure that the hose is not pinched or
bend.
• The end of the hose should not be bent, it
should not be stepped on and it must not be
folded between the drain and the product.
Connecting the water drain hose for
models with the water tank at the
bottom;
Connection pipe to water drain is at the bottom
rear of your machine.
1. Remove the bracket and the rubber cap.
2. Attach the drain hose and replace the bracket
to its position.
Important:
C There is no pump in the machine, so ensure
that the hose is placed to allow a easy water
flow.
C The end of the hose should never be higher
than the level of the water outlet on the
machine. Otherwise, the “tank full” light of
your machine will illuminate and stop the
programme.
C If the dryer is mounted on the washing
machine by means of a bracket, use of the
water drain hose is recommended. The drain
hose should be directed downwards as
shown in the figure.
Adjusting feet
In order to ensure that your product operates
more silently and vibration-free, it must stand
level and balanced on its feet. Front feet of your
product can be adjusted. Balance the machine
by adjusting the feet.