Filter
Top Products
8
EN
Refer to the nearest Authorised Service
Agent for installation of your product.
C Preparation of location and electrical
installation for the product is under
customer’s responsibility.
B Installation and electrical connections
must be carried out by a qualified
personnel.
A Prior to installation, visually check if
the product has any defects on it. If
so, do not have it installed. Damaged
products will cause risks for your
safety.
Appropriate installation
location
• Install the product in an environment
which has no risk of freezing and is in a
stable and level position.
• Operate your product in a well
ventilated, dust-free environment.
• Do not block the air ducts in front of
and under the product with materials
such as long pile rugs and cupboard
plinths.
• Do not place your product on a long
pile rug or on similar surfaces.
• Do not install the product behind a
door with a lock, sliding door or a
hinged door which can strike the
product.
• Once the product is installed, it should
stay at the same place where its
connections have been made. When
installing the product, make sure
that the rear wall of it does not touch
anywhere (tap, socket, etc.) and also
pay attention to install the product at a
place where it will stay permanently.
BDo not place the product on top of the
power cable.
•Keep at least 1.5 cm distance to walls of
other furniture.
Connection to a water drain
(for products equipped with a
condenser )
In products equipped with a condenser
unit the water accumulated during the
drying cycle is collected in the water tank.
You should drain the accumulated water
after each washing cycle.
You can directly send the accumulated
water out through the water drain hose
supplied with the machine instead of
periodically draining the water collected in
the water tank.
Connecting the water drain
hose for models with the water
tank at the bottom;
Connection pipe to water drain is at the
bottom rear of your machine.
1. Remove the bracket and the rubber
cap.
2. Attach the drain hose and replace the
bracket to its position.
Important:
C There is no pump in the machine, so
ensure that the hose is placed to allow
a easy water flow.
C The end of the hose should never be
higher than the level of the water outlet
on the machine. Otherwise, the “tank
full” light of your machine will illuminate
and stop the programme.
C If the dryer is mounted on the washing
machine by means of a bracket, use of
the water drain hose is recommended.
The drain hose should be directed
downwards as shown in the figure.
Adjusting feet
In order to ensure that your product
operates more silently and vibration-
free, it must stand level and balanced on
its feet. Front feet of your product can
3 Installation