Filter
Top Products
20
EN
Fluff filter
Lint and fibres released from the laundry
to the air during the drying cycle are
collected in the “Fluff Filter”.
C Such fibre and lint are generally
formed during wearing and washing.
C Always clean the filter after each
Drying process.
C You can clean the filter and filter area
by vacuum cleaner.
For Filter cleaning;
1. Open the cover
2. Remove the fluff filter by pulling it up
and open the filter.
3. Clean lint, fibre, and the fluff by hand or
with a soft piece of cloth.
4. Close the filter and place it back into its
seat.
C Clogging may arise on the filter
surface after using your machine for
some time; if this occurs, wash the
filter with water and dry it before using
again.
Water tank (Products equipped
with a condenser);
The moisture in the damp laundry is taken
from the laundry and condensed. Drain
the water tank after each drying cycle or
during drying when “Water tank” warning
light turns on.
CYou can use the water in the water tank
in your steam irons or air humidifiers.
A Condensed water is not drinkable!
A Never take out the water tank when
the programme is running!
Water tank may be located in two
different places as indicated below,
depending on the model of your dryer.
- Inside the drawer on the panel
- Behind the kick plate cover
If you forget to drain the water tank, your
dryer will stop during the following drying
cycles when the water tank is full and the
8 Maintenance and cleaning
“Water tank” warning light will turn on. If
this is the case, press the “Start/Pause/
Cancel” button to resume the drying
cycle after draining the water tank.
To drain the water tank:
1. Carefully remove the water tank by
opening the kick plate cover/pulling the
drawer.
2. Drain the water by opening the water
tank cover.
3. If there is lint accumulation in the water
tank cover, clean it and press to close.
4. Place the water tank back into
position.
For the condenser (products
with a condenser)
Hot and humid air in the condenser is
cooled with the cold air from the room.
Thus, the humid air circulating in your
dryer is condensed and then pumped
into the tank.
CClean the condenser after every 15
drying cycles or once a month.
To clean the condenser:
1. If a drying process has been carried
out, open the door of the product and
wait until it cools down.
2. Unlock the 4 condenser locks after
opening the kick plate.
3. Pull out the condenser.
4. Clean the condenser with pressurized
water and wait until the water drains.
5. Replace the condenser with the side of
it labelled with “Top” facing upwards.
Lock the 4 condenser locks. Make
sure that the red lock on the upper
right corner is engaged securely.
6. Close the kick plate cover.
Close properly and
check the locking
latchs?
.