Filter
Top Products
9
EN
3 Installation
To make the product ready for use,
make sure that the electricity and water
drainage system are appropriate before
installation. If they are not, call a qualified
technician and plumber to have any
necessary arrangements carried out.
C
Preparation of the product’s location
as well as the electrical and waste
water installations is the customer’s
responsibility.
C
Manufacturer shall not be held
liable for damages that may arise
from procedures carried out by
unauthorised persons.
A
Prior to installation, visually check if
the product has any defects on it. If
so, do not have it installed. Damaged
products cause risks for your safety.
A
The appliance should be
transported only in a vertical
upright position.If during
the course of transport the
appliance has to be transported
horizontally, it must only be
laid on its right hand side. After
bringing it to upright position,it
must not be operated for at least
12 hours to allow the system to
settle.
Failure to comply with the
above instructions could result
in damage occurring to the
appliance. The manufacturer will
not be held responsible if these
instructions are disregarded.
Appropriate installation
location
• Install the product on a stable and
level surface.
• Dryer is heavy. Do not move it by
yourself.
• Operate your product in a well
ventilated, dust-free environment.
• Do not block the air ducts in front of
and under the product with materials
such as long pile rugs or wooden
plinths.
• Do not install the product behind a
door with a lock, sliding door or a
hinged door which can strike the
product.
• Once the product is installed, it
should stay at the same place where
its connections have been made.
When installing the product, make
sure that the rear wall of it does
not touch anywhere (tap, socket,
etc.). Also pay attention to select an
installation location which you will not
be required to change afterwards.
• Place the product at least 1.5
cm away from the edges of other
furniture.
B
Do not place the product on the
power cable.
Removing the transportation
safety assembly
A
Remove the transportation safety
assembly before using the product for
the first time.
1. Open the loading door.
2. There is a nylon bag inside the drum
that contains a piece of styrofoam.
Hold it from its section marked with
XX XX.
3. Pull the nylon towards yourself and
remove the transportation safety
assembly.