Filter
Top Products
26
EN
CNever unscrew the adjustable feet from their
housings.
Electrical connection
Connect the machine to a grounded outlet
protected by a fuse of suitable capacity as stated
in the technical specifications table. Our company
shall not be liable for any damages that will arise
when the machine is used on a circuit without
grounding.
• Connection must comply with national
regulations.
• If the current value of the fuse or breaker in the
house is less than 16 Amps, have a qualified
electrician install a 16 Amp fuse.
• Power cable plug must be within easy reach
after installation.
• The voltage and allowed fuse or breaker
protection are specified in the “Technical
Specifications” section.
• The specified voltage must be equal to your
mains voltage.
• Do not make connections via extension cables
or multi-plugs.
• The main fuse and switches must have a
contact distance of minimum 3 mm.
BDamaged power cable must only be replaced by
a qualified electrician.
BIf the product is faulty, it must not be operated
unless it is repaired! There is the risk of electric
shock!
First use
• To have the product ready for operation before
calling the authorised service agent, make sure
that its location and power supply installations
are appropriate. If they are not, call a qualified
electrician to have any necessary arrangements
carried out.
• Make sure that the power connections of the
product are in accordance with the instructions
given in relevant chapters of this manual.
Disposing of packaging material
Packaging materials are dangerous to children.
Keep packaging materials in a safe place out
of reach of children. Packaging materials of
your product are manufactured from recyclable
materials. Sort and dispose of them in accordance
with recycled waste instructions. Do not dispose of
them with normal domestic waste.
Transportation of the machine
1. Unplug the machine from the mains.
2. Remove the water drain (if any) and chimney
connections.
3. Drain water remained in the machine
completely before transportation.
1. Remove the hose on the machine by pulling it out
from its end. Do not use any tools to take out the
hose.
2. Connect the special drain hose supplied with the
machine to the pipe fitting.
3. The other end of the drain hose can be directly
connected to the wastewater drain or to the
washbasin. The fitting must always be secured
in all types of connections. Your house may be
flooded if the hose gets out of its housing during
water discharge.
Important:
• The hose should be attached to a height of
maximum 80 cm.
• You must be careful not the pinch or bend the
hose.
• The end of the hose should not be bent, it should
not be stepped on and it must not be folded
between the drain and the machine.
Adjusting the feet
In order to ensure that your machine operates
more silently and vibration-free, it must stand level
and balanced on its feet. Balance the machine by
adjusting the feet.
Rotate the feet to adjust until the machine stands
level and firmly.