Filter
Top Products
16
EN
Auxiliary function
Low temperature
This function allows for drying at lower
temperatures and therefore saves energy.
Warning LED will light up when you select the
function.
C You must use this function when you dry
your synthetic or delicate laundry.
Warning indicators
CWarning indicators may differ according to the
model of your dryer.
Filter cleaning
A warning light will turn on to remind filter
cleaning after the programme finishes.
C If the filter cleaning warning light lights up
continuously, please refer to, “Suggested
solutions for problems”.
Water tank
A Warning LED will light up at the end of
the programme or when the tank is full
with water. The machine stops operating
when this warning LED lights up during a
programme running. To restart the machine,
please drain the water in the water tank.
Press “Start/Pause/Cancel” button to start
the programme after you have emptied the
water tank. The warning LED goes off and
the programme resumes operating.
Starting the programme
1. Press “Start/Pause/Cancel” button to start
the programme.
2. Light of the “Start/Pause/Cancel” button will
turn on to indicate that the programme has
started.
Timer follow-up indicator
One of the LEDs is on as far as programme runs
and shows the approximate remaining time.
Changing the programme after the
programme has started
You can use this feature to dry your laundry in
a different programme after your machine has
started to run.
For example;
Press and hold the “Start/Pause/Cancel” button
for about 3 seconds to select “90” minutes
programme instead of “60” minutes program.
Select the “90” minutes programme by rotating
the program knob.
Press “Start/Pause/Cancel” button to start the
programme.
C The program which is selected first will go
on even if the programme selection button
is moved and another programme mode
is selected while the machine is operating.
You must cancel the ongoing programme in
order to change the drying programme. (See,
Ending the programme through canceling)
Adding/removing laundry in standby
mode
In order to add or take out laundry after the
start-up of the programme;
1. Press the “Start/Pause/Cancel” button to
switch the machine to “Pause” mode. Drying
process will stop.
2. Open the door at Pause position and close it
again after adding or taking out laundry.
3. Press “Start/Pause/Cancel” button to start the
programme.
C Any laundry added after the drying process
was started may cause the already dried
clothes in the machine intermingle with wet
clothes and the result will be wet laundry after
the drying process is over.
Child-proof lock
There is a childproof lock to prevent any
programme interruption due to the pressing of
keys while the programme is on. The loading
door and all keys except the “On/Off” key on the
panel are deactivated when the child-proof lock
is active.
In order to activate the childproof lock, press
on the “Start/Pause/Cancel” and “Low
temperature” buttons simultaneously for 3
seconds.
To start a new programme after the programme
is over or to interrupt the programme, the
childproof lock should be deactivated. To
deactivate the childproof lock, press the same
buttons for 3 sec.
COne of the LEDs on the programme follow-up
indicator starts flashing when the child-proof
lock is activated.
C Child-proof lock is deactivated when the
machine is restarted by pressing the On/Off
button.
Ending the programme through
canceling
The programme which is selected first will keep
on going even if the position of the programme
selection button is changed. A new programme
can be selected and started after “Programme
cancel” is activated in order to change the drying
programme.
To can cel any selected programme;
• Press “Start/Pause/Cancel” button for about
a duration of 3 seconds. The “Filter cleaning”