Filter
Top Products
9
INSTALLATION INSTRUCTIONS
BEFORE USING YOUR PORTABLE WASHER
Remove the exterior and interior packing.
You will need the following tools:
Wrench
Pliers
Screwdriver
Check to be sure you have all of the following parts:
2 Inlet Hoses
2 Faucet Adapters
1 Noise Proof Plate With Screws
4 Rubber Washers
4 Casters
Remove shipping brace. Note - It should be saved and used (to prevent damage to washer
components) whenever washer is moved or transported to a new location.
Clean the interior surface with lukewarm water using a soft cloth.
Allow 2 inches of space between the back and sides of the appliance.
Put your laundry into the washer evenly. Uneven laundry may cause noise or vibration.
DO NOT use excessively hot water (122ºF / 50°C or more). Plastic parts may be deformed or
damaged. Also, clothing may be deformed or bleached.
Before washing, check all pockets. If nails or pins remain in pockets, they may damage the
washer or clothes.
Never splash water on the control panel.
Plug the washer into an exclusive properly installed-grounded wall outlet. Do not under any
circumstances cut or remove the third (ground) prong from the power cord. Any questions
concerning power and/or grounding should be directed toward a certified electrician or an
Authorized Avanti Products service center.
SELECTING A LOCATION
Before you install the portable washer, select a location with the following
characteristics:
A hard level surface (if the surface is uneven, see Adjusting The
Adjustable Foot section on the next page).
Away from direct sunlight. Direct sunlight may affect the acrylic coating,
plastic and electrical components.
Adequate ventilation.
Away from sources of heat such as coal or gas. Make sure that the
washing machine does not stand on its power cord.
Ventilation openings must not be obstructed by carpeting when the
portable washer is installed on a carpeted floor. It is recommended
that you place your portable washer on a hard material floor such as tile,
concrete, linoleum and to avoid if at all possible placement on wooden floors
or carpeted areas.
WRENCH
PLIERS
SCREWDRIVER