Filter
Top Products
16
OPERATING INSTRUCTIONS
PRESS THE POWER BUTTON.
PRESS THE WATER LEVEL BUTTON.
Choose appropriate water level according to wash load quantity.
WATER TEMPERATURE CHOICE.
Press the water temperature selection button, you can choose to from cold, warm, and/or hot water.
NOTE: The washer will provide a cold rinse in all TEMPERATURE settings.
Indicator
Light Shown
Description
C
This means that you have selected to use COOL or cold water. The washing
machine will only use water supplied by the cold water inlet.
H
This means that you have selected to use HOT water. The washing machine will only
use water supplied by the HOT water inlet.
CH
This means that you have selected to use WARM water. The washing machine will
use water supplied by both the COLD and HOT water inlets simultaneously.
IMPORTANT: A single cold hose system does not allow the washing machine to automatically
(select) regulate incoming water temperatures to match those listed on the control panel such as
WARM or HOT.
PRESS THE FUNCTIONS SELECTION BUTTON.
Choose the desired function and then the corresponding indicator blink.
PRESS DOWN START/PAUSE BUTTON ONCE AND THE MACHINE WILL BEGIN OPERATION.
Please press this button to stop the normal operation, if it continues to work, press it again.
Water level can be reset during the normal operation. If the higher water level is selected, the machine
will operate after refilling the water level selected.
MANUAL FUNCTIONS SELECTION (CUSTOM WASHING CYCLE)
WASH ONLY
Press down the power button.
Press the cycle button to until only the WASH indicator is ON.
Press the water temp button to select the water temperature.
Press the water level button to select the appropriate water level setting.
Press the START/PAUSE to start the course. And the LED display will show the remaining time of
the entire course.
WASH AND RINSE
Press down the power button.
Press the cycle button until the WASH & RINSE indicators are ON.
Press the water temp button to select the water temperature.
Press the water level button to select the appropriate water level setting.
Press the START/PAUSE to start the course. And the LED display will show the remaining time of
the entire course.
RINSE AND SPIN
Press down the POWER button.
Press the cycle button until the RINSE & SPIN indicators are ON.
Press the water level button to select the appropriate water level setting.
Press the START/PAUSE to start the course. And the LED display will show the remaining time of
the entire course.