Filter
Top Products
113062-17 Maytag Co. 15
Service/Parts Information ____________
Service
Service must be performed by a qualified trained technician,
service agency, or gas supplier. If service is required, contact
the Maytag dealer from whom the equipment was purchased.
If the dealer cannot be contacted or is unknown, contact the
Maytag Co. for a dealer in your area.
NOTE: When contacting the Maytag Co., be sure to give
them the correct model number and serial number so that
your inquiry is handled in an expeditious manner.
Parts
Replacement parts should be purchased from the dealer
from whom the Maytag equipment was purchased. If the
dealer cannot be contacted or is unknown, contact the Maytag
Co. for a dealer in your area.
NOTE: When ordering replacement parts from the Maytag
dealer or the Maytag Co. be sure to give them the correct
model number and serial number so that your parts order
can be processed in an expeditious manner.
Warranty Information _________________
Returning Warranty Cards
Before any dryer leaves the manufacturer’s test area, a
warranty card is placed on the back side of the main door
glass. These warranty cards are intended to serve the
customer where we record the individual installation date
and warranty information to better serve you should you file a
warranty claim.
IMPORTANT: A separate warranty card must be completed
and returned for each individual dryer.
NOTE: Be sure to include the installation date when
returning the warranty card(s).
Warranty
For a copy of the manufacturer’s commercial warranty
covering your particular dryer(s), contact the Maytag dealer
from whom you purchased the equipment and request a dryer
warranty form. If the dealer cannot be contacted or is
unknown, warranty information can be obtained from the
Maytag Co.
NOTE: Whenever contacting the Maytag Co. for warranty
information, be sure to have the dryer’s model number and
serial number available so that your inquiry can be
handled in an expeditious manner.
Computer Programs and Selections
Each microprocessor controller (computer) has been
preprogrammed by the factory with the most commonly used
program (parameter) selections. If microprocessor controller
(computer) program changes are required, refer to the
computer programming manual, which was shipped with
the dryer.
Shutdown Instructions ________________
In the case where the dryer is to be shutdown (taken out of
service) for a period of time, the following must be performed:
Discontinue power to the dryer either at the external disconnect
switch or the circuit breaker.
Discontinue the gas supply (for gas models only):
Shut off external gas supply shutoff valve.
Shut off internal gas supply shutoff valve located in the gas
valve burner area (for both the top tumbler and the bottom
tumbler).
Operating Instructions ________________
Starting the Dryer
The dryer is available for use when the appropriate side of
the microprocessor display reads “0 minutes” and the amount
needed to start the dryer (i.e., “25”). Once the load has been
put into the dryer and the main door is closed, start the dryer
as follows:
Insert the proper number of coins into the coin acceptor. Once
the correct “Amount To Start” has been inserted, the display
will read “SELECT CYCLE.”
Determine fabric setting (selection).
Once the fabric temperature setting (selection) has been
determined, start the dryer by pressing the fabric setting key.
The dryer will now start, and the display will read the setting
and the time vended.
The cycle time will count down until the drying and cooling
cycles are completed.
Upon completion of the drying and cooling cycles, the dryer
will shut off.
Notes
The dryer tumbler can be stopped at any time by opening the
main door. To restart dryer, shut the main door and press
desired setting.
NOTE: When a cycle is interrupted by opening the main
door, cycle time will continue to count downward,
regardless if the door is open or closed.
Selection (setting) changes can be made at any time during
the drying cycle.