Filter
Top Products
17
4. Move hinge to the other side and reattach with the 4 screws
removed in Step 2. Make sure locator pins line up in holes
and drive the top 2 screws in place first to help drive locator
pins into proper location.
5. Set the inner
door assembly aside.
Reverse the door handle
1. Place the outer door assembly face down on work space.
2. Remove the 6 screws that hold the intermediate door to the
outer door assembly. Remove the intermediate door, and set
hinge shield aside. Remove the hinge hole cover.
A.Intermediate door
B.Hinge shield
C.Hinge hole cover
B
A
C
3. Rotate the window assembly 180º and reattach the
intermediate door, hinge shield, and hinge hole cover
with the 6 screws removed in Step 2.
Reinstalling the door
1. Place the inner door assembly into the outer door assembly.
To fit correctly, the inside door assembly edge is completely
inside the outside door assembly edge.
2. Re
assemble the inner and outer door assemblies with the
5 screws.
3. Remove existing label from the opposite side of the door and
discard. Find label provided with the Use and Care Guide and
apply over original hinge holes.
4. Align the door by placing the locating tabs on the hinge with
the locating holes on the dryer front panel. Insert and tighten
the center hinge screw. The door will hang in place while you
insert and tighten the remaining 4 screws.
NOTE: T
wo or more people may be needed to reattach the
dryer door.
B
C
A
A.Dryer door
B.Dryer front panel
C.Insert this hinge screw first.
5. Close the door and check that it latches securely.
6. Che
ck for fingerprints on the glass. Clean the glass if
necessary.
Complete Installation
1. Check that all parts are now installed. If there is an extra part,
go back through the steps to see which step was skipped.
2. C
heck that you have all of your tools.
3. Di
spose of/recycle all packaging materials.
4. Check
the dryer’s final location. Be sure the vent is not
crushed or kinked.
5. Che
ck that the dryer is level. See “Level Dryer.”
6. For
power supply cord installation, plug into an outlet. For
direct wire installation, reconnect power.
7. Remove the blue pr
otective film on the console and any tape
remaining on the dryer.
8. Read “Dryer Use.”
9. Wipe the dryer drum interior thoroughly with a damp cloth to
remove any dust.
10. Sel
ect a Timed Dry heated cycle, and start the dryer. Do not
select the Air Dry Temperature setting.
If the dryer
will not start, check the following:
■ Controls are set in a running or “On” position.
■ The Start button has been pushed firmly.
■ Dryer is plugged into an outlet and/or electrical supply
is connected.
■ Household fuse is intact and tight, or circuit breaker has
not tripped.
■ Dryer door is closed.
This dryer automatically runs an installation diagnostic routine
at the start of its first cycle.
If you receive an L2 code, ther
e may be a problem with your
home power supply keeping the dryer’s heater from turning
on. See “Troubleshooting.”
If you receive an AF code, your drye
r vent may be crushed
or blocked. See “T
roubleshooting.”
NOTE:
You may notice an odor when the dryer is first heated.
This odor is common when the heating element is first used.
The odor will go away.