Filter
Top Products
CLARKE TECHNOLOGY Operator's Manual -
SCRUBTEC R Manual SteeringSCRUBTEC R Manual Steering
SCRUBTEC R Manual SteeringSCRUBTEC R Manual Steering
SCRUBTEC R Manual Steering
Page -19-
How to Operate the Forward / Reverse Switch
(see figure 28).
1. To go forward, push the up arrow side of the switch.
2. To go in reverse, push the down arrow side of the
switch.
How to Fill the Solution Tank
The solution tank fill port is located at the left side of the
machine (see figure 29). To fill the solution tank, follow this
procedure:
1. Turn the key switch to the “OFF” position.
2. Remove lid.
3. Add a cleaning chemical to the solution tank. For the
correct amount of chemical, follow the directions shown
on the container. NOTE: Excess foam in the recovery
tank could damage the vacuum motor, so use only
the minimum amount of detergent necessary.
WARNING: Always use low foam detergent. To
avoid the production of foam, before
starting to clean, put a minimum
quantity of antifoam liquid into the
recovery tank. NEVER USE PURE
ACID.
4. Fill the solution tank with clean water (see figure 29).
5. After filling the solution tank, replace the solution tank
lid.
WARNING: Water solutions or cleaning materials
used with this type of machine can
leave wet areas on the floor surface.
These areas can cause a dangerous
condition for the operator or other
persons. Always put CAUTION signs
near the area you are cleaning.
WARNING: Machines can ignite flammable
materials and vapors. Do not use
with or near flammables such as
gasoline, grain dust, solvents and
thinners. Only use a cleaning
concentration recommended by the
chemical manufacturer.
WARNING: ALTO recommends a maximum
water temperature of 120°F (49°C).
Operating the Machine
NOTE: Before scrubbing with the machine, become familiar
with the operations and handling of the machine. Run the
machine at the lowest traverse speed. Use the machine in
an area that has no furniture or objects until you can do the
following:
1. Traverse the machine in a straight direction, forward
and backward.
2. Stop the machine safely.
3. Turn the machine both left and right and return to a
straight direction.
4. Turn a 180
o
turn where one rear wheel just pivots.
How To Operate the Machine
Figure 29
Figure 28