Filter
Top Products
CLARKE TECHNOLOGY Operator's Manual -
SCRUBTEC R Manual SteeringSCRUBTEC R Manual Steering
SCRUBTEC R Manual SteeringSCRUBTEC R Manual Steering
SCRUBTEC R Manual Steering
Page -17-
How to Read the Battery Meter (see figure 21, A)
The battery meter is an indicator on the LCD display. This
indicator is on the LCD display on the front of the machine.
It has 10 bars with 10 bars visible indicating a full charge.
As you run the machine the bars will begin to lower. The
“Battery Icon” (B) will begin to flash to indicate you are
reaching the end of charge.
NOTE: If you continue to run the brushes they will shut
down to protect the batteries from over discharging.
NOTE: Run times will vary depending on machine
variables, battery size, brush pressure and floor type,
etc.
How to Change Displays Screens on the LCD Module
The LCD display has three screens. Two of them can be
accessed at any time the key is on. The first screen
shows the machine status and the second screen shows
the four hour meters (figure 21).
The two screens that can be viewed by the operator can be
accessed via the display button (figure 22) on the control
panel to the left of the key switch. Pressing this button
toggles the display between the available screens.
The third screen is for diagnostics only. This screen
displays any errors that might occur or if the system
diagnostics finds something wrong. When the diagnostic
screen comes up, refer to the trouble shooting guide for
suitable action to resolve the error code.
How to Read the Solution Empty Indicator (see figure
23, A)
The solution empty indicator is located on the front of the
machine below the LCD display. When the solution
reaches nearly empty, the indicator will begin to flash,
warning the operator of the need to refill.
NOTE: Solution run times will vary depending on
solution flow setting.
How to Read the Recovery Full Indicator (see figure
23, B)
The recovery full indicator is located on the front of the
machine below the LCD display. When the recover tank is
near full the indicator will begin to flash, warning the
operator of the need to empty the recovery tank. The
vacuum motors will shut down a few moments later.
NOTE: Recovery times will vary depending on solution
flow setting and floor type.
How To Operate the Machine
A
SCREEN 1
SCREEN 2
A
B
B
Figure 21
Figure 22
Figure 23