Filter
Top Products
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Operation
21
201932
Rapid Advance
The Rapid Advance feature allows the owner to
quickly advance into a cycle and advance an active
cycle to a specific cycle step.
To enter Rapid Advance and advance through each
cycle step, open the meter case service door (on
metered models) or the control hood (on nonmetered
models), unplug the white bullet connector with the
black/white and gray/yellow wires on the hood wire
harness for at least one second, and then reconnect it.
Each time the connector is unplugged and
reconnected, the control will advance through the
following steps:
From Ready Mode, cycle will advance to wash
fill (start of cycle).
From wash fill or agitate, cycle will advance to
wash spin following a short pause. Wait for pause
and washer to spin before advancing to next step.
From wash spin, cycle will advance to rinse fill.
From rinse fill or agitate, cycle will advance to
final spin following a short pause. Wait for pause
and washer to spin before advancing to next step.
From final spin, cycle will advance to End of
Cycle Mode.
Open lid to clear End of Cycle Mode and return
to Ready Mode.
Setting Dipswitch
Cycle settings can be changed using the 8-Position
dipswitch mounted on the control. The control reads
the dipswitch settings at power-up. The control must
be powered down to change the dipswitch settings.
The control is shipped from the factory with all the
switches in the OPEN position. Refer to the table
below for dipswitch settings.
Switch 1 is used to select whether a long or short cycle
will be used. Switch 2 is used to turn Error Mode on or
off. Switches 3 through 8 are not used at this time.
Table 1
Switch
No.
Open (Default) Closed
1 Long Cycle Short Cycle
2 Error Mode On Error Mode Off
3-8 Not Used