Filter
Top Products
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Operation
201932
20
Control Modes
Power-Up Mode
The control enters this mode after power is applied to
the washer. In Power-Up Mode, the control will detect
the state it was in at power-down to determine what
mode to enter. After the control completes operation in
the Power-Up Mode, it will enter either the Ready,
Test or Run Modes.
Ready Mode
In Ready Mode, the control will wait for the vend to be
satisfied before entering Run Mode.
Run Mode
In Run Mode, the control is running a cycle. The IN
USE LED will be lit. For metered models, any time the
control receives a coin slide pulse during a cycle, the
IN USE LED will flash briefly to indicate the coin
input. For nonmetered models, any time the control
receives a pulse from the push-to-start switch during a
cycle, the IN USE LED will flash briefly to indicate
the push-to-start input.
Lid Open Mode
The control enters Lid Open Mode when the lid is
opened during Run Mode. All cycle activity is
stopped. The cycle time count down stops unless the
lid is opened during the last three minutes of the final
spin step. In this case the time will continue to count
down.
End of Cycle Mode
The control enters End of Cycle Mode when a cycle is
complete. The IN USE LED will be off. The control
will remain in this mode until the lid is opened or vend
has been satisfied.
Error Mode
In Error Mode, the IN USE LED flashes to display fill
and drain errors (refer to paragraphs below). Error
Mode can only be exited by powering down washer.
The Error Mode can be turned off by setting dipswitch
2 to the CLOSED position. Refer to Tab le 1.
Fill Error
A Fill Error will occur if the tub does not fill within 62
minutes of the start of the cycle. A Fill Error is
indicated by the control flashing the IN USE LED
twice separated by a one and a half second pause until
the control is powered down. If Error Mode is turned
off (refer to Table 1), the fill error will not occur and
the control will continue to wait for the fill level to be
reached.
Drain Error
A Drain Error will occur if the tub is not empty after a
spin cycle. A Drain Error is indicated by the control
flashing the IN USE LED three times separated by a
one and a half second pause until the control is
powered down. If Error Mode is turned off (refer to
Table 1), the drain error will not occur and the machine
cycle will advance to the next cycle step as though the
water had been pumped out.