Alliance Laundry Systems UW125AV Washer User Manual


 
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Programming
15
F232226
NOTE: ON appears ONLY where motor control
outputs are on (otherwise they are off). Outputs
referenced are on control unit fuse board. Outputs
are as labeled on the fuse board.
NA – Not Applicable
Table 4 (Continued)
Pause 5 seconds, then Reverse
wash speed – 60 seconds, pause
several seconds before entering
drain (next step)
Display shows ‘rEv’
Outputs: Motor operates wash speed reverse; drain closed
Drain (cannot advance to spin
here)
For 2 speed models
: Display flashes “drAI”/“For” (keypad RINSE LED on)
For variable-speed models
: Display flashes “drAI”/“For” while operating in low speed
forward; then flashes “drAI”/“dISt” while operating at distribution speed.
If balance fails, repeats the “drAI”/“For” then “drAI”/“dISt” sequence above and balance
indicator is on during “drAI”/“For” message (rebalance attempt). Tries up to 10 times in
TEST cycle, then aborts test cycle.
Outputs: Drain closed for first part of step (less than 20 seconds), then drain off.
2 speed models
: Wash speed forward
Variable-speed
: Forward during “drAI”/“For”; distribution during “drAI”/“dISt”.
Spin: 2 minutes Certain models display “SPIn” (keypad SPIN LED on)
while other models display shows “HI 1” (keypad SPIN LED on)
Outputs: Spin (low spin for variable-speed – refer to motor chart below)
Highest Spin speed (variable-
speed models ONLY):
2 minutes
For 2 speed models: this step is skipped, goes to coast (the next step)
For variable-speed models: display shows “HI 2” (keypad SPIN LED on) or “HI”
Outputs: Highest spin speed selected (refer to motor chart below)
Coast Displays “SdLY” (spin delay coast)
Outputs: All off
Stop routine Display shows “01” (1 minute remaining). Agitates briefly then unlocks the door, shows
“doNE” while sounding the buzzer 10 seconds; “doNE” shows for 20 more seconds.
(DOOR LED on while showing “doNE”, meaning “door ready to open”).
Motor Speed Chart
Variable-Speed Motor Control
Outputs
Fixed Speed and
2Speed Motor
Outputs
STF STR RH RM RL Fwd Rev Spin
Motor off (no rotation)
Wash speed forward ON ON ON
Wash speed reverse ON ON ON
Distribution (variable-speed ONLY) ON ON NA NA NA
Lowest spin (low spin speed “HI 1” for
variable-speed)
ON ON ON ON
Medium spin (“HI 2” – variable-speed ONLY) ON ON ON NA NA NA
Highest spin (“HI 3” – variable-speed ONLY) ON ON ON NA NA NA