Filter
Top Products
7
685980
Installing the Washer
Step 1: Position Washer Near
Installation Area
IMPORTANT: Install dryer before washer. This
allows room for attaching exhaust duct.
Move washer as close to the desired area of
installation as possible.
Step 2: Connect Water Inlet
Hoses
NOTE: Refer to section on Water Supply
Requirements before connecting water inlet hoses.
Remove the four plain rubber washers from
accessories bag, and install them according to the
illustration.
Turn on the water supply faucets and flush the lines for
approximately two minutes to remove any foreign
materials that could clog the screens in the water
mixing valve.
NOTE: When installing in newly constructed or
renovated building, it is very important to flush the
lines since build-up may have occurred during
construction.
IMPORTANT: Thread hose couplings onto valve
connections finger-tight, then approximately 1/4
turn with pliers. DO NOT cross thread or
overtighten couplings.
Turn water on and check for leaks. If leaks are found,
retighten the hose couplings. Continue tightening and
rechecking until no leaks are found.
D772I
D772I
W528I
1 Rubber Washer (Plain)
2 Install This End of Hose to Water Supply
Faucet
3 Install This End of Hose to Valve
Connections at Rear of Washer
4 Inlet Hose
H328I
1 Water Supply Faucets
2 Cold Water Connection
3 Hot Water Connection
4 Water Inlet Hoses
1
2
3
4
H328I
1
2
3
Water
Mixing
Valve
4