Filter
Top Products
Installing the Washer
685980
10
Step 4: Position and Level the
Washer
Place washer in position on a clean, firm and
reasonably level floor. Installing the washer on any
type of carpeting is not recommended.
Loosen 7/8" locknut and adjust the front and rear leveling
legs until the washer is level from side to side and front
to back (using a level). Washer should not rock.
NOTE: Level must rest on raised portion of top
panel. See illustration.
Tighten the locknuts securely against the washer
base using the 7/8" wrench. If the locknuts are not
tight, washer will move out of position during operation.
NOTE: DO NOT slide washer across floor if the
leveling legs have been extended, as legs and base
could become damaged.
NOTE: Use of the dispenser drawer or washer door
as a handle in the transportation of the washer may
cause damage to the dispenser or door.
Remove rubber feet from accessories bag and place on
all four leveling legs.
Washers elevated above floor level must be
anchored to that elevated surface, base or
platform. The material used to elevate the
washer should also be anchored to the floor
to ensure that the washer will not walk or
that the washer can not be physically
pulled, tipped or slid from its installed
position. Failure to do so may result in
conditions which can produce serious
injury, death and/or property damage.
W306
WARNING
H359I
1 Leveling Leg
2 Washer Base
3 Level
4 Locknut
5 Rubber Foot
1
3
4
5
2