Filter
Top Products
-24-
201959
Reinstallation of Shipping
Materials
You must install the shipping brace and shipping
plug any time the washer is moved.
Shipping Brace
• The shipping brace in the lid opening should
be saved and reinstalled whenever the
washer is moved. To reinstall the brace, open
the washer lid and place the brace over the
washer agitator, placing the back of the
brace into the washtub first.
Shipping Plug
• The plastic shipping plug should be saved and
reinstalled any time the washer is moved. The
plug fits into two openings: The base opening
and the shipping plug opening on the bottom
of the mobile pivot dome. The plug MUST be
inserted into both openings to prevent
damage to the washer. In order to
accomplish this, the shipping plug opening
must be directly lined up with the base
opening. Refer to illustrations below.
• After the shipping brace has been installed in
the lid opening, tilt washer back enough to
access base opening.
• Insert shipping plug into base opening and,
using the palm of your hand, push shipping
plug into washer until it snaps into shipping
plug opening.
Motor Overload Protector
• The internal motor overload protector will
stop the motor automatically if there are
too many clothes in the washtub or if a
failure has occurred within the machine. The
overload protector will reset itself in two or
three minutes and the motor will restart
automatically. If the overload protector
stops the motor again, remove the washer
from use and call the service person to
correct the problem.
TLW2044N
Shipping
Plug Opening
Base
Opening
Shipping
Plug
TLW2044N
Shipping
Brace