Filter
Top Products
-14-
201959
To Clean the Dispenser
Remove the dispenser housing from agitator by
squeezing the lower part of the dispenser, pulling
directly upward and at the same time tilting
slightly. This will expose the dispenser cup, which
is also removable, for cleaning (refer to
illustration). Both housing and cup can be soaked
in hot soapy water and rinsed clean. The funnel
shape in top of agitator also needs to be cleaned.
The hole and the slots in the two rings will require
using a small brush for proper cleaning.
After cleaning, install dispenser cup, then push
dispenser housing directly downward onto top of
agitator until firmly snapped together.
Use Tips
• Fabric softener spilled onto garments may
cause staining. To remove, dampen stain and
rub with bar soap. Wash as usual.
• Liquid fabric softeners will be dispensed
during the final rinse and should not be
combined with bleach, bluing, starch,
detergents, soaps or packaged water
conditioners.
• Fabric softener is not to be used in
dispenser when using Prewash cycle, if
available.
• When adding detergent to wash water, do
not allow any to enter into softener
dispenser cup, as softener will become
gummy.
To prevent softener buildup, the dispenser can be
filled with clean water for automatic cleaning. This
can be done in washing cycles other than when
softener is used.
Agitator Cap
IMPORTANT: If your washer comes with an
agitator cap, the cap must be on at all times.
TLW2001N
Dispenser Housing
Dispenser Cup
Agitator
TLW2001N