Filter
Top Products
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 800975
4
Operating Instructions
Timer
Although the washer cycles are automatic, the timer
may be reset to lengthen, shorten or repeat a portion of
a cycle.
To set or reset the timer, push timer knob in to stop the
washer. Hold timer knob in firmly while slowly
turning it clockwise to the setting desired. Pull timer
knob out to start the washer.
DOOR LOCKED Light
When the washer is started, the DOOR LOCKED light
will come on after a short delay. The light will turn off
10 to 30 seconds after the cycle is complete.
Out of Balance Load
If at the end of the cycle, the load is dripping wet, the
washer has limited the spin speed. This is to prevent
damage to the unit if there is a severely unbalanced
load.
If this condition occurs, redistribute the load manually
and repeat the cycle beginning at the last rinse.
If the condition persists, consider steps discussed in
the Before Washing section of the Use and Care
Guide.
End of Cycle Signal
The volume of the signal tone may be set on OFF,
LOUD or between the two selections. If a volume
level is selected, the signal tone will buzz on and off
when the cycle is completed. The signal will stop
when the door is opened, or when the timer has
advanced to an OFF position.
NOTE: If the signal comes on and remains on, the
washer may have sensed an error. Unplug the
washer, shut water off to washer and contact a
service person.
W549I
WI