Alliance Laundry Systems HC80 Washer User Manual


 
Maintenance
60
F232062
Daily
(Continued)
End of Day
1. Clean the door gasket of residual detergent
and all foreign matter.
2. Clean automatic supply dispenser lid
and general area. Flush dispenser with
clean water.
3. Clean the washer’s top, front, and side
panels with mild detergent. Rinse with
clean water.
4. Leave loading door open at the end of each
day to allow moisture to evaporate.
Note:
Unload the machine promptly
after
each completed cycle
to prevent moisture
buildup. Leave loading door open
after
each
completed cycle
to allow moisture to
evaporate.
Weekly
1.
For variable-speed models only,
clean
the AC drive box filter(s) weekly or more
frequently as needed:
Note:
If fan filter service indicator light is on,
fan filter must be cleaned immediately to
prevent possible damage. Press thermostat
button to reset indicator light.
a. Open the top cover.
b. Grasp the filter handle and pull straight
up to remove filter.
c. Wash the filter with warm water and
allow filter to air-dry. As an alternative,
the filter may be vacuumed clean.
2. Check the machine for leaks.
a. Start an unloaded cycle to fill
the machine.
b. Verify that door and door gasket do
not leak.
c. Verify that the drain valve is operating
and that the drain system is free
from obstruction. If water does not
leak out during the prewash segment,
the drain valve is closed and
functioning properly.
Monthly
Note:
Disconnect power to the machine at
its source before performing the monthly
maintenance procedures.
1.
For 80-pound capacity models only,
lubricate bearings and seals each month
OR after every 200 hours of operation.
See Figure 49.
a. Use a premium-grade lithium-based #2
grease. Never mix two types of grease,
such as petroleum and silicone.
The control module cover and fan filter must
be in place for the fan to properly cool the
AC inverter drive. Failure to observe this
warning will void the warranty and could
lead to expensive AC inverter drive repair.
SW038
WARNING