Filter
Top Products
Installation
32
F232062
Mechanical Installation
(Continued)
6. Use compressed air or a squeeze bulb to
clean out each hole. See Figure 18.
Figure 18
7. Install the machine anchors, using the
included tool.
8. Secure the machine to the floor, using the
bolts furnished with the anchors. Tighten
the locknuts by even increments—one
after the other—until all are tightened
evenly and the machine is fastened
securely to the floor. See Figure 19.
Figure 19
The completed expansion bolt installation is
shown in Figure 20.
Figure 20
Note:
Check and retighten the locknuts after
five to ten days of operation and every three
months thereafter.
H028I
H029I
H030IE1A
Locknut
Machine
Base
5/8 in. (19 mm)
diameter
Expansion
Bolt
Washer