Filter
Top Products
Maintenance
F232215
18
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
4. Remove back panel and check overflow hose and
drain hose for leaks.
5. Unlock the hinged lid and check the supply
dispenser hoses and hose connections.
6. Clean inlet hose filter screens:
a. Turn water off and allow valve to cool, if
necessary.
b. Unscrew inlet hose and remove filter screen.
c. Clean with soapy water and reinstall. Replace
if worn or damaged.
7. Tighten motor mounting bolt locknuts and
bearing bolt locknuts, if necessary.
8. Use compressed air to clean lint from motor.
9. Use compressed air to ensure that all electrical
components are free of moisture and dust.
10. Verify that the insulation is intact on all external
wires and that all connections are secure. If bare
wire is evident, call a service technician.
Quarterly
NOTE: Disconnect power to the machine at its
source before performing the quarterly
maintenance procedures.
1. Tighten door hinges and fasteners, if necessary.
2. Using a Teflon-based spray lube, lubricate the
door lock by applying the spray to the door lock
pin while turning the door handle.
3. Verify that the drain motor shield is in place and
secure, if so equipped.
4. Check all painted surfaces for exposed metal.
(Matching paint is available from the
manufacturer.)
● If bare metal is showing, paint with primer or
with a solvent-based paint.
● If rust appears, remove it with sandpaper or by
chemical means and then paint the affected
area with primer or with a solvent-based paint.
5. Clean supplied steam filter, where applicable.
Refer to Figure 12.
a. Turn off steam supply and allow time for the
valve to cool.
b. Unscrew Cap.
c. Remove Element and clean.
d. Replace Element and Cap.
Figure 12
6. Measure the out-of-balance switch gap setting
and adjust it as needed. Refer to the Installation
Manual, which is supplied with the machine.
7. Check the bearing mounting bolts to make sure
they are torqued properly. Refer to Table 3 for
specifications.
Table 3
H042I
1 Cap
2 Filter Element
Machine
Capacity
Bearing Torque
125 Front 500 ft.-lbs.
125 Rear 140 ft.-lbs.
H042
I
1
2