Filter
Top Products
Page 11
Operating Instructions - Two Timer Models
OPERATING
INSTRUCTIONS -
TWO TIMER
MODELS
1. After loading the dryer tumbler with water washed clothes load, proceed to
close the loading door. For better drying, do not load dryer with combina-
tion of garments that twist.
2. Turn the 60-minute drying timer to the desired drying time. The drying
cycle light will be on and indicate the drying. The light shuts off when
drying time is complete. (See figure 1)
3. Turn the 15-minute cooling cycle timer to the desired cool down time. (Note:
Dryer will not start unless some cooling time is selected!). After the
drying cycle is completed, then the cooling cycle time will automatically
operate. The cooling light will be on and indicate the cooling of the clothes
load. The light shuts off when cooling time is completed. (See figure 1 )
4. Temperature Selector - Select temperature per type of load being dried in
the dryer. (See figure 2 )
High Heat - Mixed and heavy fabrics, set dial to 195º F (91° C).
Normal - Cottons and linens, set dial to 170º F (77° C).
Permanent Press Heat - Poly knit synthetics, blends, lightweight fabrics,
set dial to 150º F (66° C).
Low Heat - Delicate, sheer fabrics, easy-to-dry, set dial to 135º F (58° C).
5. Thermometer - Use this with your temperature selection. Teach yourself
what temperature is too hot or too cold. (See figure 3 )
6. Turn switch to “start” position. (See figure 1 )
7. Close the dryer door, but the basket will not rotate until the PUSH-TO-
START BUTTON is pressed. Press in the PUSH-TO-START BUTTON
(approximately 2 seconds) until the dryer starts running and then release
button. (See figure 1)
What is happening to the drying operation:
a. The fan motor will operate.
b. The basket will rotate.
c. The heat source will be energized.
d. The heated air mix with the water washed clothes to evaporate the
moisture from the garments.
e. The thermostats will function to maintain a safe temperature through
out the drying cycle.
f. The heat will be shut off and the motor will continue to run to cool the
dry load to a desired handling temperature.
8. When the drying timer completes its time, then the cooling timer will be
energized and the cooling light will be “On”. When the cooling light will
stay “On” and the “End-of-Cycle” light will be “On”. The “End-of-Cycle”
light will go off when the “Start/Stop” switch is turned to “Off” or “O”. At
the end of the cool-down cycle, the clothes load is dry.
(Continued on next page.)