Filter
Top Products
Operation
13
70400401
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
DMP OPL Features
DIP Switch Settings
The DMP has an 8 position DIP switch bank that is
accessible from the back of the control board. By
switching these DIP switches, it is possible for the
operator to customize the display and some of the
operating features of the tumbler.
DIP Switch Functions Explained
1. Tumbler Type: This DIP switch selects the type
of tumbler, i.e., OPL or Coin.
2. Temperature Units: Selects ºF or ºC for the
temperature display. Factory setting is for ºF.
3. Local/Remote Reversing: Preset at the factory;
usually for local reversing. Remote reversing for
use with Reversing Timer Board only.
4. Empty: Preset at the factory; always ON.
5. Empty: Preset at the factory; always ON.
6. Buzzer Timer: This DIP switch determines the
length of time that the end of cycle buzzer will
remain on. “OFF” indicates that the buzzer will
sound for 5 seconds when the drying cycle is
completed. “ON” indicates that the buzzer will
sound continuously until the STOP button is
pressed, or the loading door is opened.
7. Safety Tumble, Display Count, or Pay: If DIP
switch #1 is set for OPL, then DIP switch #7 in
the ON position enables the safety tumble. If DIP
switch #1 is set for Coin, then DIP switch #7 in
the display of “PAy,” to indicate that coins are
needed to run the tumbler.
8. Programming: This switch enables or disables
the programming feature and should normally be
in the OFF position.
Function OPL Coin
1
Tumbler Type OFF ON OPL=Off; Coin=On
2
Temperature Units OFF OFF ºF=Off; ºC=On
3
Local/Remote
Reversing
ON ON Local=On; Remote=Off
4
Empty ON ON Always ON
5
Empty ON ON Always ON
6
Buzzer Timer ON ON 5 Sec=Off; Continuous=On
7
Safety Tumble (OPL)
or Coin Count/Pay
(Coin)
ON OFF
#1 #7 DIP SWITCH
OFF ON SAFETY TUMBLE
OFF OFF NO SAFETY TUMBLE
ON ON COIN COUNT
ON OFF PAY
8
Programming OFF OFF Disable=Off; Enable=On
Table 2