Filter
Top Products
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Installation
17
70304601
Position and Level the Tumbler
Unscrew the four shipping bolts (one at each corner).
Remove tumbler from skid carefully to avoid putting
pressure on the lower blower housing or motor
assembly.
NOTE: Do not throw bolts away – they are the
leveling legs.
Remove four nuts from the literature package, and
screw one fully on to each leveling leg.
Screw the four leveling legs (bolts) back into the level
adjusting fittings from the bottom.
Slide tumbler to its permanent location. Adjust the
leveling legs until the unit is level within 0.125 inch
(32 mm) higher in the front. Refer to Figure 2.
Tumbler must not rock. Lock leveling legs with nuts
previously installed.
NOTE: The front of the tumbler should be slightly
higher than the rear (approximately 0.125 inch,
3.18 mm). This will prevent the clothes, while
tumbling, from wearing on the door glass gasket.
IMPORTANT: Keep tumbler as close to floor as
possible. The unit must rest firmly on floor so
weight of tumbler is evenly distributed.
Figure 2
The stacked tumbler has a fifth leveling leg which is
shipped in the up position. The fifth leveling leg
MUST BE installed properly on the lower left side of
the blower housing to stabilize the tumbler. Refer to
Figure 3.
After leveling with the four cabinet leveling legs,
lower the fifth leveling leg so it contacts the floor, and
then secure the screws.
Figure 3
TMB1975N
1 Leveling Leg
T467I
1 Fifth Leg
The stacked drying tumbler has a 5th
leveling leg on the blower housing. It is very
important to properly adjust this leg. Unit is
back heavy and could rock or tip.
W250
CAUTION
1