Filter
Top Products
504490
11
Before You Call For Service . . .
(You may save time and money by checking the following:)
If Your Dryer:
If Service Is Required . . .
If service is required, contact the nearest Factory
Authorized Service Center.
If you are unable to locate an authorized service center
or are unsatisfied with the service performed on your
dryer, write to:
Alliance Laundry Systems LLC
Shepard Street
P.O. Box 990
Ripon, WI 54971-0990
Phone: (920) 748-3950
When calling or writing about your dryer, PLEASE
GIVE THE MODEL AND SERIAL NUMBERS. The
model and serial numbers are located in one of the four
corners of the door well. The door well is the shaded
area shown.
Please include a copy of your bill of sale and any
service receipts you have.
Won’t
Start
Won’t
Heat
Doesn’t Dry
Clothes
Satisfactorily
Possible Reason — Do This To Correct
•
Dryers equipped with power cord — be sure the power cord is plugged
all the way into the electrical outlet.
• Close the loading door.
• Be sure timer is not in COOL DOWN setting or NO HEAT cycle.
• Push timer knob in to start dryer.
••
(Electric Dryers
Only)
Has the laundry room fuse(s) blown or become loosened, or are circuit
breakers open? The dryer itself does not have an electrical fuse. An
electric dryer has an electrical circuit with two fuses.
• Has the motor overload protector cycled? Wait 10 minutes and try again.
• Is the timer in a heat setting?
•
Gas Dryer Only — Check to see if equipment and main gas line valve is
turned on.
••
Check exhaust duct to outside to see if it is kinked, blocked or needs
cleaning.
••
Check weather hood to make sure flapper moves freely, has not been
pushed in or has not been blocked.
• Automatic Cycle — Adjust to more or less dry setting.
• Timed Cycle — Allow more or less time.
• Clean the lint filter.
• Is the load too small? Small loads may not tumble properly or dry evenly.
D324IE0C
To reduce the risk of serious injury or
death, DO NOT repair or replace any part of
the dryer or attempt any servicing unless
specifically recommended in the user-
maintenance instructions or in published
user-repair instructions that you
understand and have the skills to carry out.
W133
WARNING