Filter
Top Products
20
Adjusting the level of conductivity
Water contains, a variable quantity of limestone and mineral salts of
which quantities vary according to geographical locations thus vary-
ing its conductivity values.
Relevant variations of the conductivity of the water compared to
those prefixed by the factory could slightly influence the residual
humidity of the laundry at the end of the cycle.
Your dryer allows you to regulate the sensitivity of the drying sensor based on
conductivity values of the water by using the following procedure.
Procedure:
Turn the programme selector dial to switch on the appliance
In selection mode press simultaneously the buttons 3 and 6 until «
CC00
»
appears on the digits.
Adjusting the level of conductivity:
Press the button 5 sequentially: the level of conductivity is indicated
by the lighting of the horizontal hyphens.
Normally, the appliance is factory-set to the highest level; howe-
ver, certain models may be configured differently.
Memorizing the new setting:
Simultaneously press down the buttons 3 and 6 until the previous
drying cycle time appears again on the display and the buzzer sounds.
DISPLAY
Conductivity degree
Approximative value
µS/cm (25°C)
CC00
--
Low < 300
CC00 --
Medium 300 - 600
CC00 --
High > 600
6
1
2
3
45
Adjusting the level of conductivity
--
--
--
37800_UK.qxp 7/1/2005 2:43 PM Page 20