Filter
Top Products
Problem Possible cause Possible solution
The appliance fills
with water and
drain immediately.
The end of the drain
hose is too low.
Make sure that the drain hose is
in the correct position.
The washing re-
sults are not satis-
factory.
The detergent you used
was not sufficient or cor-
rect.
Increase the detergent quantity
or use a different one.
You did not remove the
stubborn stains before
you wash the laundry.
Use special products to remove
the stubborn stains.
Incorrect temperature
was set.
Make sure that you set the cor-
rect temperature.
Too much laundry load. Decrease the laundry load.
After the check, activate the appliance.
The programme continues from the
point of interruption.
If the problem occurs again, contact the
service centre.
If the display shows other alarm codes,
contact the service centre.
SERVICE
• Refer to the information supplied
with this appliance for guarantee
condition and point of contact. The
information to give to the service is
on the rating plate.
We recommend that you write the in-
formation here:
Model
(MOD.)
..................
Product number
(PNC)
..................
Serial number
(S.N.)
..................
TECHNICAL DATA
Dimensions Width / Height / Depth 605 / 850 / 605 mm
Total depth 640 mm
Electrical connection: Voltage
Overall power
Fuse
Frequency
230 V
2200 W
10 A
50 Hz
Water supply pressure Minimum 0,5 bar (0,05 MPa)
Maximum 8 bar (0,8 MPa)
Water supply
1)
Cold water
ENGLISH 25