Filter
Top Products
If you fit your own plug, the colours of the wires in the mains lead of your
appliance may not correspond with the markings identifying the terminals in
your plug, proceed as follows:
Connect the green and yellow (earth) wire to the terminal in the plug which
is marked with the letter «E» or the earth symbol or coloured green and
yellow.
Connect the blue (neutral) wire to the terminal in the plug which is marked
with the letter «N» or coloured black.
Connect the brown (live) wire to the terminal in the plug which is marked
with the letter «L» or coloured red.
The plug moulded on to the lead incorporates a fuse. For replacement, use a
13 Amp BS1362 fuse. Only ASTA or BSI approved fuses should be used.
The plug must not be used if the fuse cover/carrier is lost. The cover/carrier is
indicated by the coloured insert at the base of the plug.
A replacement cover/carrier must be obtained from your local AEG/ELEC-
TROLUX Service Centre.
Permanent connection
In the case of a permanent connection it is necessary that you install a dou-
ble pole switch between the appliance and the electricity supply (mains), with
a minimum gap of 3 mm between the switch contacts and of a type suitable
for the required load in compliance with the current electrical regulations.
The switch must not break the yellow and green earth cable at any point.
This operation should only be performed by a qualified electrician.
50
Installation
132984470.qxd 09/10/2006 10.12 Pagina 50