AEG L 12510 VI Washer User Manual


 
Set the machine
upright and remove
the two remaining
bolts from the back.
Pull out the three
plastic spacers from
the holes into which
the bolts were fit-
ted.
Plug the open holes with the plugs which you will find in the plastic bag
containing the instruction booklet.
You are advised to keep all transit devices so that they can be refitted if the machine
ever has to be transported again.
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the machine is not impeded by carpets,
rugs etc.
Before placing it on small tiles, apply a rubber coating.
Never try to correct any unevenness in the floor by putting pieces of wood,
cardboard or similar materials under the machine.
If it is impossible to avoid positioning the machine next to a gas cooker or
coal-burning stove, an insulating panel (85x57 cm) covered with alumini-
um foil on the side facing the cooker or stove, must be inserted between
the two appliances;
The machine must not be installed in rooms where the temperature can
drop below 0°C.
The water inlet hose and the drain hose must not be kinked.
Please ensure that when the appliance is installed, it is easily accessible for
the engineer in the event of a breakdown.
Levelling
Carefully level by screwing the adjustable feet
in or out. Never place cardboard, wood or sim-
ilar materials under the machine to compen-
sate for any unevenness in the floor.
46
Installation
132984470.qxd 09/10/2006 10.12 Pagina 46