AEG 76730 Washer User Manual


 
Instructions for use
35
Fault code EF0
appears.
The anti-flood system Aqua
Control has responded.
Close the water tap. Turn the
programme knob to OFF (UIT,
ARRET). Call your after-sales
service.
Conditioner not added,
compartment w for
care agent full of
water.
Softener insert in the com-
partment for care agent not
correctly attached or is
blocked.
Clean the detergent drawer
and firmly attach the sof-
tener insert.
Washing heavily
creased.
Too mush washing probably
put in.
Pay attention to the maxi-
mum filling quantity (see
Program Tables). For easy-
care textiles, select the pro-
gram EASY IRON (STRIJKVRIJ,
SANS REPASSAGE).
Washing not well spun.
Residual water still vis-
ible in the drum.
Fault code
E20
appears. The indicator
RINSE (SPOELEN,
RINCAGE) flashes.
Drainage hose bent. Remove the bend.
Maximum pump head (outlet
head 1m from unit's floor
surface) exceeded.
Consult Customer Service.
They can supply a retrofit kit
as a special accessory for
delivery heads of more than
1m.
Solution pump blocked.
Switch off the unit and pull
out the mains plug. Clean
the solution pump.
If a siphon is connected:
Siphon blocked.
Clean the siphon.
The main door cannot
be opened while the
appliance is turned on.
The main door is locked
because of a high water level
or a high temperature. The
display DOOR (DEUR, PORTE)
is not lit.
Wait until the display DOOR
(DEUR, PORTE) lights up
green.
Should it nevertheless be
necessary to open the main
door:
Turn the programme knob to
OFF (UIT, ARRET); turn the
programme knob to PUMP
OUT (POMPEN, VIDANGE).
Press button START/PAUSE
(START/PAUZE, MARCHE/
ARRET). The main door can
be opened after the water
has been pumped out.
Problem Possible Cause Remedy