Filter
Top Products
34
Something not working
Something not working
Certain problems are due to lack of simple maintenance or oversights, which can be
solved easily without calling out an engineer. Before contacting your local Service Centre,
please carry out the checks listed below.
During machine operation it is possible that the
yyeellllooww
Start/Pause pilot light flashes, one of
the following alarm codes appears on the display and at the same some acoustic signals
sound every 20 seconds to indicate that the machine is not working:
• E10 : problem with the water supply
• E20 : problem with the water draining
• E40 : door open.
Once the problem has been eliminated, press the
SSttaarrtt//PPaauussee
button to restart the
programme. If after all checks, the problem persists, contact your local Service Centre.
Problem Possible cause/Solution
The washing machine does not
start:
The door has not been closed. E40
• Close firmly the door.
The plug is not properly inserted in the power socket.
• Insert the plug into the power socket.
There is no power at the socket.
• Please check your domestic electrical installation.
The main fuse has blown.
• Replace the fuse.
The selector dial is not correctly positioned and the
Start/Pause button has not been depressed.
• Please turn the selector dial and press the
Start/Pause button again.
The delay start has been selected.
• If the laundry are to be washed immediately, cancel
the delay start.
The machine does not fill:
The water tap is closed. E10
• Open the water tap.
The inlet hose is squashed or kinked.
E10
• Check the inlet hose connection.
The filter in the inlet hose is blocked.
E10
• Clean the water inlet hose filter.
The door is not properly closed.
E40
• Close firmly the door.
132971880 gb.qxd 31/08/2007 12:51 Pagina 34