Filter
Top Products
Operating Instructions
31
Washing heavily
creased
Probably too much washing
put in the drum.
Pay attention to the maxi-
mum load quantity (see Pro-
gram tables). In the case of
easy-care fabrics, select the
EASY IRON program.
The washing is not suf-
ficiently spun. Water is
left in the drum.
The fault code
E20
appears . The RINSE
display flashes.
Drain hose is kinked. Remove the kink.
Maximum pump head (dis-
charge height 1m from the
appliance's base) is exceeded.
Contact your local Service
Force Centre. For pumping
heights over 1m a conver-
sion kit is available as a spe-
cial accessory.
Drain pump is blocked.
Switch off the appliance and
pull out the mains plug.
Clean the drain pump.
The door cannot be
opened when the
appliance is switched
on.
The door is locked due to a
high water level or a high
temperature. (the DOOR dis-
play is off).
Wait until the DOOR display
lights up green.
If it is still necessary to open
the door:
turn the program selector to
OFF turn the program selec-
tor to PUMP OUT. Press the
START/PAUSE button
After the water has been
pumped out, the door can be
opened.
Remnants of detergent
are building up in the
detergent dispenser
drawer.
Water tap is not fully
opened.
Open the water tap fully.
The inlet hose filter in the
coupling inlet hose at the
tap is blocked.
Close the water tap. Unscrew
the inlet hose from the water
tap and from the appliance.
Clean the filter.
The rinsing water is
cloudy.
The cause is probably a
detergent with a high silicate
content.
No negative effect on the
rinsing results, use a liquid
detergent if necessary.
When pressing a pro-
gram option button
the corresponding dis-
play does not light up.
The selected program option
cannot be combined with the
set program.
Make another selection.
Problem Possible Cause Remedy