Filter
Top Products
Operating Instructions
30
The washing machine
vibrates during opera-
tion or is unstable.
The machine is not level.
Adjust the feet according to
the installation and connec-
tion instructions.
There is very little washing in
the drum (e.g. only one
dressing gown).
This does not impair the
function.
The water could not be com-
pletely pumped out before
spinning because the drain-
age hose is kinked or the
drain pump is blocked.
Check the the drain hose and
remove any kink if necessary,
or clean the drain pump and,
if required, remove foreign
bodies from the pump hous-
ing.
Excessive foaming dur-
ing the main wash.
Probably too much detergent
was used.
It may be necessary to
reduce the amount of deter-
gent used. Follow the deter-
gent manufacturer's
recommendations.
Water runs out from
under the washing
machine.
The screw connection on the
inlet hose is leaking.
Tighten the inlet hose screw
connection
The drainage hose is leaking.
Check the drainage hose and
replace it if necessary.
The washing drain pump
cover is not correctly closed.
Close cover correctly.
Washing is caught in the
door.
Stop the program and
remove the washing caught
in the door. Restart the
program.
The emergency emptying
hose is not correctly closed
or is leaking.
Close the emergency empty-
ing hose correctly (see the
section "Carrying out emer-
gency emptying"). Call your
local Service Force Centre if
the emergency emptying
hose leaks.
Fabric softener was not
washed in, compart-
ment w for condi-
tioners is filled with
water.
The conditioner insert in the
compartment for the condi-
tioners is not correctly
attached or is blocked.
Clean the detergent dis-
penser drawer and attach the
conditioner insert securely.
Problem Possible Cause Remedy