Filter
Top Products
When discharging into a standpipe
ensure that the top of the standpipe is
no more than 90 cm (35.4'') and no less
than 60 cm (23.6'') above floor level.
The drain hose may be extended to a
maximum of 4 metres. An additional
drain hose and joining piece is available
from your local Service Force Centre.
The joining piece must have an internal
diameter of 18 mm.
If your drain hose looks like this (see the relevant
pcture) you do not require the “U” piece”. Just push
the hose firmly into the standpipe.
2. Onto a sink outlet spigot.
If the outlet spigot has not been used before, remove any blanking plug that may
be in place.
Push the drain hose onto the spigot and secure with a clip if required, ensure a
loop is formed in the drain hose (see diagram) to prevent waste from the sink
entering the washing machine.
The drain hose may be extended to a maximum of 4 metres. An additional drain
hose and joining piece is available from your local Service Force Centre. The join-
ing piece must have an internal diameter of 18 mm.
If you intend the drain hose
from the machine to empty
into a sink, make sure that
the sink is empty and the
plug hole is not blocked.
Use the plastic “U -Piece”
supplied.
Important
Before connecting up the machine to new pipework or to pipework that has not
been used for some time, run off a reasonable amount of water to flush out any
debris that may have collected in the pipes.
44
Installation
3 pin
Max. 90 cm.
(35.4")
Min.60 cm.
(23.6")
Loop
132969060 gb.qxd 12/09/2007 9.22 Pagina 44