Filter
Top Products
displayed for about 2 seconds and the yellow
pilot light of button 8 light starts blinking.
Alarm codes
In the event of operating problems, some alarm
codes can be displayed, for example
E20 (see
paragraph «Something not working»).
End of programme
When the programme has finished a blinking
zero is displayed, the DOOR and WASHING pilot
lights and the pilot light of button 8 go out and
the door can be opened.
Select the START/PAUSE (Button 8)
To start the selected programme, press the button 8, the corresponding red pilot
light stops blinking.
The WASHING pilot light is on to indicate that the appliance starts operating.
The DOOR pilot light is on to indicate the door is locked.
To interrupt a programme which is running, depress the button 8: the
corresponding red pilot light starts to flash.
To restart the programme from the point at which it was interrupted, press the
button
88
again.
If you have chosen a delayed start, the machine will begin the countdown.
If an incorrect option is selected, the integrated yellow pilot light of the button 8
blinks for 3 times the message Err is displayed for about 2 seconds.
Select the DELAY START (Button 9)
Before you start the programme, if you wish to delay the start, press the
button 9 repeatedly, to select the desired delay.
The selected delay time value (up to 20 hours) will appear on the display for
about 3 seconds, then the duration of the programme will appear again.
You must select this option after you have set the programme and before you
press the button 8.
The wash programme can be delayed from 30 min - 60 min - 90 min, 2 hours
and then by 1 hour up to a maximum of 20 hours by means of this button.
16
Use
132969060 gb.qxd 12/09/2007 9.22 Pagina 16