Filter
Top Products
Troubleshooting
32
Washing has not been
spun well, there is
water left in the drum.
Drain hose is kinked. Eliminate the kink.
Maximum pumping height
(drain height 1m from the
position of the machine) is
exceeded.
Please contact the customer
service, it has a retro-kit
available for pump heights
above 1m.
Suds pump is blocked.
Switch off the machine and
pull the plug out of the
socket, clean the suds pump.
If a siphon is connected: the
siphon is blocked.
Clean the siphon.
The door cannot be
opened.
Program is not yet finished,
(ON/OFF) display lamp
lights up.
Wait until the (ON/OFF)
lamp goes out.
The rinse water is
cloudy.
Probably caused by a wash-
ing powder with a high sili-
cate content.
This does not negatively
affect the rinse results. If
necessary use liquid deter-
gent.
Remnants of detergent
are building up in the
detergent drawer.
Tap is not fully open. Open tap fully.
The sieve in the threaded fit-
ting on the water inlet hose
at the tap is blocked.
Clean sieve.
Sieve on threaded fitting for
the water inlet hose on the
machine is blocked.
Clean sieve.
Program selector skips
(PRE WASH).
(PRE WASH)
combined with
(WOOLLENS).
(PRE WASH) can-
not be combined with
(WOOLLENS).
Program selector stops
at
(SOAKING).
(SOAKING)
combined with
(WOOLLENS).
(SOAKING) cannot
be combined with
(WOOLLENS).
Stain remover is not
washed in.
(STAIN)
combined with
(WOOLLENS).
(STAIN) cannot
be combined with
(WOOLLENS).
Malfunction Possible cause Remedy