AEG 60810 Washer User Manual


 
32
Water inflow
A 1.50 m long pressure hose is supplied with the appliance.
If a longer water inlet hose is required, only original hoses are to be
used. The Customer Care Department stocks hose kits of different
lengths.
3 Sealing rings are either inserted in the nuts of the threaded hose fitting
or are included as spare parts . Do not use any other type of sealing
rings.
Important! All threaded hose fit-
tings must only be tightened by
hand.
1.Connect the hose with the right-an-
gle connector to the machine.
Important! Do not position the inlet
hose vertically downwards. Position
it to the right or the left as shown in
the illustration.
2.Connect the hose with the straight
connector to a water tap with an R
¾ (inch) screw thread.
3.To tighten or loosen the threaded
hose fitting, only the metal nuts
must be turned. When doing this,
keep a firm hold on the housing of
the safety valve with one hand, so
that it does not turn at the same
time.
Important! To tighten or loosen the
threaded hose fitting, never turn the
housing of the safety valve, as oth-
erwise the inner hose will be dam-
aged.
4.Open the water tap slowly and check all connections for water tight-
ness.