Filter
Top Products
20
E10 appears.
indicator (END)
flashes 1x, at the same
time an acoustic signal
sounds 1x.
(Problems with water
inflow)
Tap turned off. Turn on the tap.
The filter in the threaded in-
let hose fitting is blocked.
Turn off the tap. Unscrew the
hose, take out the filter and
clean it.
Water tap is furred with
lime scale or is faulty.
Check the tap and have it re-
paired, if necessary.
The washing machine
vibrates when operating
or is not stable.
The transit packaging has
not been removed.
Removing the transit pack-
aging.
The screw feet not correctly
adjusted.
Adjust the feet as described
in the installation and con-
nection instructions.
Washing has not been
spun.
Only a few large items of
washing in the drum.
Always load the drum as full
as possible. Mix large and
small items.
Water is running out
from under the washing
machine.
Screw connection on the in-
let hose is leaking.
Screw the inlet hose on
tightly.
Drain hose is leaking. Replace drain hose.
Drain pump cover is not
closed properly.
Close the cover properly.
Washing was caught in the
door.
Load washing carefully for
the next wash.
Emergency drain hose is
leaking.
Close off emergency drain
hose properly.
Washing water is foam-
ing excessively. At the
end of the washing cy-
cle, the spin stops.
Probably too much deter-
gent has been used.
Follow the manufacturer's
instructions exactly when
measuring out detergent.
E20 appears.
indicator (END)
flashes 2x, at the same
time an acoustic signal
sounds 2x.
(Problems with water
outflow)
Kink in drain hose. Straighten the hose.
Maximum pumping height
of 1m exceeded.
Please contact the Customer
Care Department.
Drain pump is blocked.
Switch off the appliance.
Disconnect the power plug.
Clean the drain pump. Re-
move foreign bodies from
the pump housing.
For sink spigot connections:
The sink spigot is blocked.
Clean the sink spigot.
Problem Possible cause Remedy