Filter
Top Products
33
Something not working
Problem Possible cause/Solution
The machine fills then empties
immediately:
The end of the drain hose is too low.
• Refer to relevant paragraph in «water drainage»
section.
The machine does not empty
and/or does not spin:
The drain hose is squashed or kinked. (Yellow
Start/Pause pilot light flashes)
• Check the drain hose connection.
The drain pump is clogged. (Yellow Start/Pause
pilot light flashes)
• Clean the drain pump.
The option has been selected.
• Disable the option .
• Select the option or .
The laundry is not evenly distributed in the drum.
• Redistribute the laundry.
There is water on the floor:
Too much detergent or unsuitable detergent (creates
too much foam) has been used.
• Reduce the detergent quantity or use another one.
Check whether there are any leaks from one of the
inlet hose fittings. It is not always easy to see this as
the water runs down the hose; check to see if it is
damp.
• Check the water inlet hose connection.
The drain hose is damaged.
• Change it with a new one.
The cap on the emergency emptying hose has not
been replaced after cleaning the pump.
• Put the cap back on the emergency emptying and
place the latter back in its seat.
192999930.qxd 6/19/2008 1:36 PM Page 33