Filter
Top Products
16
Interrupting a programme/adding washing
Interrupting a programme
• A washing programme can be interrupted at any time by pressing the
S/P (START/PAUSE) button. It is then re-started by pressing the
S/P (START/PAUSE) button again.
• To stop the washing machine before the programme has ended, turn
the programme knob to O (OFF). Important! Be careful if there is
water in the appliance!
Adding washing
It is possible to add washing, as long as the K (DOOR) light is not lit.
1.Press the S/P (START/PAUSE) button. The door can be opened.
2.Shut door and press the S/P (START/PAUSE) button again. The pro-
gramme continues.
End of the wash programme/Removing the washing
When the programme has finished, E (END) will illuminate in the pro-
gramme progress display. As soon as the K (DOOR) indicator has gone
out and the E (END) indicator is illuminated, the door can be opened.
1.Open the door and remove the washing.
2.Turn the programme knob to O (OFF).
3.Turn off the tap.
4.After the machine has finished washing, pull out the detergent drawer
a little to let it dry out. Keep the door very slightly open so that the
washing machine can air.
If n (RINSE HOLD) was selected:
After a rinse hold K (DOOR) and E (END) will illuminate in the pro-
gramme progress display.
The water must first be drained:
– Either turn the programme selector to O (OFF), then to p (DRAIN)
and press the S/P (START/PAUSE) button (water is drained and
there is no spin cycle),
– or turn the programme selector to O (OFF) and then to C (SPIN). De-
pending on the type of washing, if required reduce the spin speed
and press the S/P (START/PAUSE) button (water is drained and
there is a spin cycle).