AEG 52600 Washer User Manual


 
26
3 Special spanner A and sealing caps B
(2 units) and C (1 unit) come with
the appliance.
3.Use special spanner A to remove
screw D and the compression spring.
4.Use sealing cap C to cap the hole.
5.Use special spanner A to remove the
two screws E.
6.Use special spanner A to remove the
four screws F.
7.Remove transit bar G.
8.Screw in the four screws F again.
9.Use sealing caps B to cap the two
large holes.
Important: Press all sealing caps B
(2 items) and C (1 item) in firmly so
that they snap into the rear wall.
Where to install
Important! The washing machine must not be operated in a room
where there is a danger of frost. There is a risk of frost damage or ad-
verse effect on the perfomance of the machine. Frost damage is not
covered under the warranty.
The surface on which the appliance is to be installed must be firm
and level. Do not install the appliance on carpeted floors or soft floor
coverings.
The surface on which the appliance is to be installed must be clean
and dry and free from grease, so that the appliance does not slide.
If the location in which the appliance is to be installed is fitted with
small-format tiles, put a rubber mat (available in the shops) under
the appliance.
If the appliance is to stand on a floor which moves, e.g. a suspend-
ed wooden floor:
Place the appliance in an area as close as possible to a corner of the
room.
1.Screw a water-resistant wooden board (at least 15 mm thick) onto at
least 2 of the floor joists.