Filter
Top Products
19
The washing machine
vibrates when operating
or is unstable.
The transit packaging has
not been removed.
Remove the transit packag-
ing.
The screw feet have not
been correctly adjusted.
Adjust the feet as described
in the installation and con-
nection instructions.
There is very little washing
in the drum (e.g. just one
bathrobe).
Operation is not affected by
this.
Water is running out
from under the washing
machine.
The inlet hose screw con-
nection is leaking.
Tighten the inlet hose.
The outlet hose is leaking. Replace outlet hose.
The drain pump lid has not
been closed properly.
Close the cover properly.
Washing was caught in the
door.
Load washing carefully for
the next wash.
The emergency drain hose is
leaking.
Screw on the emergency
drain hose firmly.
There is a lot of foam.
Too much detergent has
probably been used.
Follow the manufacturer's
instructions exactly when
measuring out detergent.
The END indicator is
flashing 2x.
(Problems with the wa-
ter outflow.)
There is a kink in the outlet
hose.
Straighten the hose.
The maximum pump height
of 1m has been exceeded.
Please contact your local
Service Force Centre
The drain pump is blocked.
Switch off the appliance.
Disconnect the power plug.
Clean the drain pump. Re-
move foreign bodies from
the pump housing.
For sink spigot connections:
the spigot is blocked.
Clean the spigot.
Conditioner has not
been rinsed in, com-
partment w for condi-
tioner is filled with
water.
The conditioner insert in the
compartment for additives
has not been correctly in-
serted or is blocked.
Clean the detergent drawer,
insert the conditioner insert
firmly.
Problem Possible cause Remedy