Filter
Top Products
32
Something not working
Something not working
Certain problems are due to lack of simple maintenance or oversights, which can be
solved easily without calling out an engineer. Before contacting your local Service Centre,
please carry out the checks listed below.
During machine operation it is possible that the
yellow pilot light of button 7 flashes, one
of the following alarm codes appears on the display and at the same some acoustic signals
sound every 20 seconds to indicate that the machine is not working:
• E10 : problem with the water supply
• E20 : problem with the water draining
• E40 : door open.
Once the problem has been eliminated, press button
7 to restart the programme. If after
all checks, the problem persists, contact your local Service Centre.
Problem Possible cause/Solution
The washing machine does not
start:
The door has not been closed. E40
• Close firmly the door.
The plug is not properly inserted in the power socket.
• Insert the plug into the power socket.
There is no power at the socket.
• Please check your domestic electrical installation.
The main fuse has blown.
• Replace the fuse.
The selector dial is not correctly positioned and the
button
7 has not been depressed.
• Please turn the selector dial and press button 7
again.
The machine does not fill:
The water tap is closed. E10
• Open the water tap.
The inlet hose is squashed or kinked.
E10
• Check the inlet hose connection.
The filter in the inlet hose is blocked.
E10
• Clean the water inlet hose filter.
The door is not properly closed.
E40
• Close firmly the door.
132966340_EN.qxd 22/11/2007 8.58 Pagina 32