Filter
Top Products
58
Installation on vibrating floors
Where the floor vibrates, particularly in the case of wooden beam
floors with pliable boards, securely screw a water-resistant wooden
panel at least 15mm thick onto at least 2 floor planks. If possible, set up
the unit in the corner of a room, as the wooden floor is optimally re-
strained there and is therefore least likely to be subject to resonance vi-
brations.
Compensate for floor unevenness
3
Automatic adjustment foot: The rear left foot of your washing ma-
chine is designed as a spring leg. This means that it guarantees that
your unit will stand securely even at high spin speeds.
If, nevertheless, the washing machine is unstable during spinning,
please proceed as follows:
0 1.Set the three adjusted feet at the
nominal value of 10 mm. To do
this, use the supplied special
spanner to remove the transport
safeguard.
If the automatically adjusting
foot does not reach the floor:
2.Automatic adjustment foot (rear
left) manually for extending the
reqired dimension.
3.If necessary, check the setting
with a spirit level.
Caution! Never use wood, card or similar underlays to level out minor
floor unevenness. Instead, always adjust
the adjustment foot.