Filter
Top Products
requirements. A minimum water pressure of 0.05
MPa is required for safe operation of the appliance.
If you cannot make the cold water connection direct
from the rising mains, you may be able to operate the
appliance from your cold water storage system. There
should be a minimum distance of between the appli-
ance’s inlet and the bottom of the water storage tank.
Water-stop device
The inlet hose is provided with a water stop device,
which protects against damage caused by water leaks in
the hose which could develop due to natural ageing of
the hose. This fault is shown by a red sector in the
window “
AA
”. Should this occur, turn the water tap off
and refer to your Service Centre to replace the hose.
Water drainage
This appliance is designed to be permanently plumbed into your home's drainage
system using one of the following methods.
1. Into a drainage standpipe.
Firstly form a hook in the end of the drain hose using
the “U” piece” supplied.
Place the drain hose into your standpipe, which
should have an internal diameter of approximately
38mm thus ensuring there is an air break between
the drain hose and standpipe.
47
Installation
P1199
U piece
supplied
A
352
30 cm (12")
38 mm (1.5)
standpipe
diameter
132966761.qxd 29/05/2008 11.15 Pagina 47