Filter
Top Products
12
Display
The display shows the following information:
Duration of the selected programme
After selecting a programme, the duration is displayed in hours and minutes (for
example
2.05). The duration is calculated automatically on the basis of the
maximum recommended load for each type of fabric. After the programme has
started, the time remaining is updated every minute.
Delay start
The selected delay (20 hours max) set by pressing the relevant button appears on
the display for a few seconds (for example
90’), then the duration of the
previously selected programme is displayed. The DELAY START symbol will appear
on the display. The delay time value decreases by one unit every hour and then,
when remains 1 hour, the time decreases every minute.
Selected drying time
After selecting a drying programme, the drying time is displayed in minutes
and/or hours. After the programme has started the time remaining is updated
every minute.
Incorrect option selection
If an option which is not compatible with the set wash programme is selected,
the message Err is displayed for a few seconds and the yellow light of button
7
starts blinking.
Alarm codes
In the event of operating problems, some alarm codes can be displayed, for
example
E20 (see chapter «What to do if...»).
End of the programme
When the programme has finished a blinking zero 0 is displayed, the DOOR
symbol disappears and the door can be opened.
If your laundry is not removed during 10 minutes after the programme is
finished, the backlight of the display switches off and the energy saving system
will be enabled. Only the pilot light of the button
8 is blinking to indicate that
the appliance has to be switched off. By pressing any buttons the appliance will
come out from the energy saving status and you could set another washing
programme or swich off the appliance.
DRYING TIME DURATION - symbol
DELAY START - symbol
9.8
9.9
9.7
132966761.qxd 29/05/2008 11.14 Pagina 12